Answer:
B false it is illegal to only have got fog lights on though and bright headlights because it can distract other drivers going last and if the y are distracted then that will cause a collision
Hope this helps :)
Explanation:
Question 10: What is a K-turn?
Answer:
The three-point turn (sometimes called a Y-turn, K-turn, or broken U-turn) is the standard method of turning a vehicle around to face the opposite direction in a limited space, using forward and reverse gears. This is typically done when the road is too narrow for a U-turn.
4. Two technicians are discussing the evaporative emission monitor. Technician A says that serious monitor faults cause a blinking malfunction indicator lamp
(MIL) or even an engine shutdown. Technician B says that the engine computer will run the EVAP monitor when fuel level is within 15 to 25 percent and the TP
sensor position is between 9 and 10 percent. Who is correct?
O A. Neither Technician A nor B
O B. Both Technicians A and BN
O C. Technician A
OD. Technician B
Answer:
The correct option is;
Neither Technician A nor B
Explanation:
The evaporative emission monitor or Evaporaive Emission Control System EVAP System monitors enables the Power Control Module of the car to check fuel system leak integrity and the vapor consumption efficiency during engine combustion
It is a requirement of EPA on cars to check the emission of smug forming evaporates from cars
Serious monitor faults can cause the turning on of the check engine lights and the vehicle will not pass OBD II test, but it will not lead to engine shutdown
It runs when the engine is 15 to 85% full and the TP sensor is between 9% and 35%.
Therefore, the correct option is that neither Technician A nor B are correct.
The knob at the front of the miter saw about belt height is used to adjust the miter angle true or false
Answer:
True.
Explanation:
There are two basic saw angles, and the little nob on the front controls the one angle, and the one on the rear controls the other.
Prescription eye protection suitable for an electrician should always include a. a safety strap b. soft nose guards c. side shields d. tinted lenses
Answer:
The correct option is;
Side shields
Explanation:
Electricians working at a construction site are exposed to arc flashes and sparks which can enter into the eyes causing painful sensation as such a prescription eye protection suitable for an electrician according to OSHA regulations the employer should ensure that the electrician makes use of eye protection that has side protection in situations that include hazards from flying objects.
a steal bar with 1 in diameter has been subjected to a tensile force of 3 tons find tensile stress in the bar
Answer:
stress = 8,556 Psi. or (stress = 59 Mpa)
Explanation:
stress = force / area
force P = 3 tons (convert to lbs. for units consistency)
1 ton = 2240 lbs.
P = 6,720 lbs.
steel bar Diameter D = 1 in. (convert to d
Area of steel bar = (π * 1²) / 4 = 0.785 in²
therefore, stress = 6720 lbs. / 0.785 in²
stress = 8,556 Psi.
in Mpa ----- 8556 Psi * 0.00689476 MPa/Psi = 59 Mpa
Tech A says never disconnect sensors before conducting resistance checks. Tech B says automotive test lamps should not be used on digital circuits because they draw too much current and can overload the circuit. Who is correct?
Answer:
12345263636636363663636e6ee66e6e6e63777e
A 6V battery is connected in series with two bulbs. What would the voltage drop be across each bulb?
Answer:
3V
Explanation:
When you arrive at an intersection with a stop sign in your direction, if there is no marked stop
line, you must
A: Stop within 10 feet of the intersecting roadway, on top of the pedestrian crosswalk if there is one.
B: Wait for pedestrians in the crosswalk to cross, then stop on the pedestrian crosswalk.
C: Stop before entering the pedestrian crosswalk.
Answer:
The answer is B. Wait for the pedestrians in the crosswalk to cross, then stop on the pedestrian crosswalk.
Based on the concept of road usage, and the available options, when you arrive at an intersection with a stop sign in your direction, if there is no marked stop line, you must Stop before entering the pedestrian crosswalk.
What is Pedestrian Crosswalk?Pedestrian Crosswalk is a term that is used to describe a place designated for pedestrians to cross a road, street, or avenue.
Generally, the term "pedestrian crosswalk" is also used in the Vienna and Geneva Conventions, both of which pertain to road signs and road traffic.
In this case, it is expected that when you arrive at an intersection with a stop sign in your direction, if there is no marked stop line, you must stop at the edge of the intersection just before entering the crosswalk or intersection.
It's important to come to a complete stop to ensure that it is safe to proceed before proceeding through the intersection. Be careful and aware of your surroundings to ensure a safe and steady flow of traffic.
Hence, in this case, it is concluded that the correct answer is option C. Stop before entering the pedestrian crosswalk.
Learn more about Pedestrian Crosswalks here: https://brainly.com/question/30752570
#SPJ2
What is meant by engineering job?
Hope so it helps you
Answer:
Engineers work in a variety of fields to analyze, develop and evaluate large-scale, complex systems. This can mean and improve and maintaining current systems or creating brand new projects. Engineers will design and draft blueprints, visit systems in the field and manage projects.
Which of the following is the last step in creating a budget?
A. Identify income
B. Identify variable expenses
C. Identify fixed expenses
D. Determine savings or debt
Answer:
D. Determine saving or debt
Explanation:
Engineers mainly concentrate on ____.
a. creating new ideas (such as designing hydrogen-powered automobiles)
b. modifying existing ideas (such as designing a fast computer)
c. creating ideas and then implementing them
d. both a and b
Answer:
d creating new ideas and modifying
The image shows a reconstruction of a pyramid with a square base. What is the best estimate for the volume of the pyramid?
A.
1,460,040 m3
B.
2,433,400 m3
C.
4,380,120 m3
D.
7,300,200 m3
Answer:
B 2,433,400 m3
Hope that helped you
Based on the calcualtions, the best estimate for the volume of the pyramid is: B. 2,433,400 m³.
How to calculate the volume of a pyramid.Mathematically, the volume of a pyramid is calculated by using this formula:
[tex]Volume = \frac{1}{3} \times base\;area \times height[/tex]
For the base area:
The area of a square is given by:
A = S²
A = 230²
A = 52,900 m².
Now, we can determine the volume:
Volume = 1/3 × 52,900 × 138
Volume = 2,433,400 m³.
Read more on pyramid here: brainly.com/question/16315790
A large piece of ground is developed with lights, streets, and sewers. The subdivider wants to get it ready for building. He does an environmental impact statement and makes a large map which shows where each lot and block is located. Streets, parks, and utility easement are also shown. This is visual representation is called:
Answer:
Subdivision plat map
Explanation:
A subdivision plat map is a map plan of a given scale having the planned lot subdivisions and amenities. Subdivision plat map also show easement boundaries, access routes, streets and alleyways present in or adjacent to the tract of land that is being subdivided into lots
The process of subdivision of a tract land of land requires the approval the counties and the cities in which the land is located.
Question 6: Which of the following is NOT true if you are changing into a
turning lane?
You should activate your signals 100 feet beforehand
You should activate your signals when you get into the turn lane
You should activate your signals before you get into the turn lane
You should use your hands to signal if your lights do not work
Answer:
You should activate your signals 100 feet before you turn, becuase of that you should not wait until you are turning to turn on your signals. If you do not have working lights use your hands. So the answer that is inccorect is B.
You should activate your signals when you get into the turn lane is NOT true
Because you are supposed to single beforhand not while you're in the lane.
Im taking my drivers ed too. :)
What is the value of current if a 50c charge flows in a conductor over a period of 5 seconds
After adjusting your seat, your___ should be as closest possible to the back rest.
Answer:
ans would be back as back is the thing that needs rest by getting closest to seat
The ramp in the railway station has rough surface .why?
Answer:
To increase the friction so we do not slip while walking.
Explanation:
If the surface is smooth then the frictional force between the ramp and the feet becomes less and the chances of slipping are greater.
If sail boats A and B are approaching each other with the wind on different sides, why is vessel A considered the give-way vessel (vessel that must take early and substantial action to avoid a collision)?
Answer:
The reason is because when the wind approaches each sailboat from a different side, the sailboat that the wind approaches from the port side, which is the left side is the give-way vessel.
Whereby the wind approaches the vessel A from the port (left) side then vessel A is considered the give-way vessel
The give-way vessel is the vessel that will have to take expeditious steps to create access for the other vessels by either changing course, stopping, or moving with reduced speed
Explanation:
what recent major breakthroughs are attributed to engineers in improving the quality of our everyday lives?
From the mass production of the automobile to space travel, from the telephone to the Internet, and from bioengineered foods to clean water, engineers have applied their expertise to improve the quality of our lives
Engineers are looking for a new material to build the body of an airplane. They agree that the material must be lightweight, but also strong and long-lasting. Above all, the material must maximize the safety of the passengers. Several engineers have developed some initial plans. Which stage of technological design is described in this passage
Answer:
Design a solution
Explanation:
In the design a solution stage, solutions and ideas to solve the problem or design of the product are generated and details of the problem solution or product design are developed
The generated ideas and details are put together to get a workable solution
Stages of technological design, includes
1) Problem identification
2) Design a solution or designing of a product
3) Design Implementation
4) Solution or product evaluation
what is the difference between science and engineering?
Answer:
The following table is among some of the discrepancies between some of the different topics.
Explanation:
Science seems to be the application of structured organized facts which could be interpreted scientifically because when engineering would be a branch of science which deals with either the profession of acquiring including using technological, computational, economical and severity of adverse effects to design and manufacture equipment and devices that seem to be beneficial to mankind.Science would be a set of information and established frameworks whereas the use of these models and information to construct structures as well as mechanisms becomes engineering.In the event you get pulled over for a traffic stop, describe the situation from the police officers perspective. Please give me the right answer.
Answer:
The police officer probably saw me violate a rule of the traffic law, thus why he pulled me over for a traffic stop. He definitely expects from me, that I will cooperate with him, and not give him any trouble. Furthermore, he would also be keeping a tight watch over me and my actions, and try to read my intentions.
define uniform velocity?
Uniform velocity refers to those velocity in which equal displacement is covered in equal interval of time....
why is engineering profession important
how many types of engineering specialist are there?
There are now six major branches of engineering: Mechanical, Chemical, Civil, Electrical, Management, and Geotechnical, and literally hundreds of different subcategories of engineering under each branch.
There are about 40 types of engineering specialists
Which resource can tell you what types of insulation you can use in a given installation? a. NESC b. NFPA c. NIOSH d. NEC
Answer:
D. NESC
Explanation:
first of all what's the meaning of NESC:
NESC: National Electrical Safety Code
The National Electrical Safety Code is a United States standard of the safe operation, maintenance, and installation of communication ,
utility system and electric power.
Which includes the following.
1.) power and communication underground lines
2.)power and communication overhead lines,
3.) Power substations
NESC are the ones to tell us the type of installation to use for a particular operation and particular location.
For both safety purposes and to reduce life hazard and community hazard due to elect item.
if you experience brake failure...
Answer:
If your brakes go out, you want to do three things.
Explanation:
First, downshift to a lower gear. Second, if you have regular brakes pump the brake pedal fast and hard to build up brake fluid pressure. Gradually apply the parking brake and be prepared for the car to skid. hope this helps you :)
2. What is the charge, expressed in micro coulombs on two equally and similarly charges spheres placed in air with their centres 30 cm apart repelling each other with a force of 120 mgm.
Answer:
q = 0.1086 micro Coulombs
Explanation:
By Coulombs law, we have;
[tex]F =k \times \dfrac{ q_1 \times q_2}{r^2}[/tex]
Where;
F = The electric force = 120 mgm
q₁ and q₂ = Charge
r = The separating distance = 30 cm = 0.3 m
k = 8.9876×10⁹ kg·m³/(s²·C²)
Where, q₁ and q₂, we have;
[tex]F =k \times \dfrac{ q^2}{r^2}[/tex]
Whereby the force is the force of 120 milligram mass, we have;
0.00012 × 9.81 = 000011772 N
[tex]q = \sqrt{ \dfrac{ F\times r^2}{k}}[/tex]
Substituting the values, we have;
[tex]q = \sqrt{ \dfrac{ 000011772 \times (0.3)^2}{8.9876 \times 10^9}} = 1.086 \times 10 ^{-7} \ Coulombs[/tex]
q = 0.1086 micro Coulombs.
What is kinetic energy?
Answer:
kinetic energy means energy which a body possesses by virtue of being in motion
Answer:
Kinetic Energy is a type of energy which a body possesses by virtue of being in motion.
OR
It's the energy of mass in motion.
Hope it helps!!Please mark me as the brainliest!!!Thanks!!!!
Your friend wears earbuds while driving to school each day. Is this safe? Is it legal? Explain why or why not.
Answer:
Its not safe but it isn't illegal. Its not safe because if their volume was up they wouldn't be able to hear if someone is honking at them or listen to emergency vehicles. They would be oblivious to what's going on around them.
Explanation:
im an amazing guy <3